Make fabric roses tutorial

How to Make Fabric Flowers

Materials:

- Ribbon : Copper strip 50 cm, Black strip 25cm.

- Needle and yarn.

- Glue gun.

How to Make Fabric Flowers

Step 1: Fold down 2/3 width of the copper strip ( fold  one end of the strip) as picture.

Step 2: Fold up the below part of the strip that the border of the strip parallel and immediately fit with the line fold edge.

Step 3: Sew 2 the fold edge together with tack stitch from bottom end to the end of the strip.

Step 4: After we sew to the end of the strip we have the strip like the picture:

Insert the outside fabric to have a triangle shape and sew tack stitch to finish this step.

Step 5: Make a small bud by just rolling one end a few times. Once you have a little bud secure it by going through all thicknesses of your roll.

Here’s where you start twisting and securing. Over…and over.  You will wrap you fabric around along the tack line, hold it down with your finger. and then back down–your needle going down almost right where it went up to make a tiny little stitch, down through to the bottom of the flower again, back and forth, tacking and securing it as you go.

Step 5: With a needle and strong thread sew gathering stitches along
the long, raw edge of fabric strip. I used upholstery thread.Pull up gathering stitches, being careful not to twist the fabric strip to form a circle. And glue the rose on the that circle. You have a rose for hair accessories or more ….

We are done!

And this is cute rose hairband

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>